The B4-6x6 is a non-penetrating antenna support designed to handle an 1.2M antenna. The simple design of the B4-6x6 makes the unit an easily installed, cost-effective mounting system.
Non-Penetrating, flat roof antenna supporting system.
Handles up to and including a 4' (1.2M) antenna.
Ku and C band-transmit and receive.
Footprint - 6.25' x 6.00' = 37.5 sq.ft.
Finish - Hot dip galvanized
Mast Diameter - as required up to 3-1/2 O.D.
Mast Height - 3' max. (for most installations)
The mount is also available with an expanded footprint.
The B4-6x8.6 has two additional trays to hold more ballast and distribute the load over a larger area.
Footprint - 6.25' x 8.67' = 54.2 sq.ft.
Finish - Hot dip galvanized
Mast Diameter - as required up to 3-1/2 O.D.
Mast Height - 3' max. (for most installations)
Ballast required will be recommended based on antenna diameter, type and survival requirements.
It is the customer’s responsibility to see that all applicable codes are satisfied. It is suggested that a structural engineer review the application of this product.
An engineering report is available to assist with determining the proper amount of ballast.
A pad can be supplied to isolate the mount from the roof surface.
Under extreme wind conditions the mount should be tethered with cable.
Our mounts are used to support satellite dishes ranging from 18” DSS up to 6 meter antennas.
Baird mounts have also been used to support:
•Microwave antennas
•Cameras (weather,news, surveillance..)
•Cellular antennas
•Off-air antennas (vhf,uhf….)
•Wireless
•Weather instruments
•Laser communications
Also contact SEG for Baird custom mounts, in ground poles, mast adapters, penetrating mounts, ridgemount – non penetrating mounts and other custom fabricated mounts for your communications systems.